| 1. | Rengör ventilröret från korrosion och smuts. Kontrollera att ytan är ren och mjuk, samt inflödesstället för TPMS-sensorskruven ( fig.1 ), gummibrickan och ventilenheten( fig.3 ), TPMS-bricka ( fig.4 )och TPMS-muttern ( fig.5 ) i listen. |
| 2. | Ta bort TPMS-sensorskruven ( fig.1 , brickan ( fig.4 )och muttern ( fig.5) från TPMS-sensorenheten. |
| 3. | När du håller i TPMS-sensorenheten ( fig.2 , plastsidan på TPMS-sensorn som är vänd mot däcket, ska du trycka TPMS-sensorvärdesröret ( fig.3 )genom listen för hand tills TPMS-gummibrickan ( fig.3 ) möter den invändiga kanten på listen. |
| 4. | Lock the TPMS sensor ( fig.2) and TPMS sensor value stem assembly together by screw ( fig.1 ). |
| 5. | Hold TPMS sensor body ( fig.2 )down against the rim drop center and thread/tighten TPMS sensor washer ( fig.4 )and nut ( fig.5 )to 35 inch-pounds or 4..0 newton-meters. |
| fig.1 | TPMS sensor screw | fig.2 | TPMS sensor ( mounted inside wheel ) |
| fig.3 | TPMS sensor valve stem,rubber washer and valve core assembly |
fig.4 | TPMS washer ( mounted outside wheel ) |
| fig.5 | TPMS sensor nut ( mounted outside wheel ) | fig.6 | TPMS sensor cap |
|
each time a tire is serviced or dismounted, or if the TPMS sensor( fig.2 ) is removed, it is MANDATORY to replace the TPMS sensor washer( fig.4 ) , TPMS sensor nut( fig.5) , and TPMS sensor valve core ( fig.3 ) with CUB parts to ensure proper sealing. It is MANDATORY to replace the TPMS sensor if it is externally damaged. |
| NOTE use only CUB service component kits designed for TPMS sensor. |
|
Warning: The TPMS sensor nut must be properly installed and tightened for proper installation. Carefully follow instructions and use a torque wrench to ensure proper installation. Failure to torque the TPMS sensor nut properly will void the warranty and TPMS may not function properly. |
|
|